If using the VST2 or VST3 Plug-in system folder, switch this on. If using Audio Units (AU), switch ‘Use Audio Units’ on. In any event, make sure to switch ‘Off’ both VST2 and VST3 locations first, hit Rescan, then switch them back ‘On’ and hit Rescan again. If using a VST3 or VST2 Plug-in Custom Folder, make sure your PROCESS.AUDIO plug-ins are actually installed in this folder and switch it on (usually C:\Program Files\VSTPlugins). This is where your PROCESS.AUDIO plug-ins are installed by default (C:\Program Files\Common Files\VST3). If using Live > 10 and VST3, enable the System folder. Try to spot the Plug-In Sources section (usually at the bottom of the pane). Open Live's Preferences > Plug-ins (Live 10.1 and later) or > File Folder (all Live versions until 10.1). If the plug-ins show up at this point, you're set.
Close Ableton, and then right-click and select ‘Run as Administrator’ (you will only have to do this once). Library/Audio/Plug-Ins/VST3/ (VST3) Live 10+ onlyĬ:\Program Files\Common Files\VST3 (VST3) Live 10+ onlyģ. Live 8 and 9 only use VST2 plug-ins wherease Live 10+ can use VST3 plug-ins.
Make sure your plug-ins are installed in the correct and default locations: Ableton Live 8 and 9 need to be installed with their 64-bit installers whereas Ableton Live 10 is already 64-bit only.Ģ. So make sure you are NOT running your DAW in 32-bit in a 32-bit environment. PROCESS.AUDIO plug-ins are compatible with Ableton Live 8 and above in 64-bit mode ONLY.ġ. PROCESS.AUDIO plug-ins are 64-bit only. Ableton Live - my plug-ins aren't showing up
0 kommentar(er)
